![background image](http://html.mh-extra.com/html/samsung/sgh-c210/sgh-c210_service-manual_1190393009.webp)
SAMSUNG Proprietary-Contents may change without notice
Circuit Description
2-5
This Document can not be used without Samsung's authorization
2-2-5. Memory
This system uses SHARP's memory, LRS18B0.
It is consisted of 256M bits flash memory and 64M bits SCRAM. It has 16 bit data line, D[0~15] which is connected to
trident, LCD or CSP2200. It has 23 bit address lines, A[1~23]. They are also connected. CP_CSROMEN signal, chip
select signal in the trident, enable flash memories. They use supply voltages, VCCD and VCC_1.8A.
During wrting process, CP_WEN is low and it enables writing process to flash memory and SCRAM. During reading
process, CP_OEN is low and it output information which is located at the address from the trident in the flash memory or
SCRAM to data lines. Each chip select signals in the trident select flash memory or SCRAM. Reading or writing
procedure is processed after CP_WEN or CP_OEN is enabled. Memories use FLASH_RESET, which is buffered signal of
RESET from CSP2200, for ESD protection. A[0] signal enables lower byte of SCRAM and UPPER_BYTE signal enables
higher byte of SCRAM.
2-2-6. Trident
Trident is consisted of ARM core and DSP core. It has 20K*16bits RAM 144K*16bits ROM in the DSP. It has
4K*32bits ROM and 2K*32bits RAM in the ARM core. DSP is consisted of timer, one bit input/output unit(BIO), JTAG,
EMI and HDS(Hardware Development System). ARM core is consisted of EMI, PIC(Programmable Interrupt Controller),
reset/power/clock unit, DMA controller, TIC(Test Interface Controller), peripheral bridge, PPI, SSI(Synchronous Serial
Interface), ACCs(Asynchronous communications controllers), timer, ADC, RTC(Real-Time Clock) and keyboard interface.
DSP_AB[0~8], address lines of DSP core and DSP_DB[0~15], data lines of DSP core are connected to CSP2200. A[0~20],
address lines of ARM core and D[0~15], data lines of ARM core are connected to memory, LCD and YMU762.
ICP(Interprocessor Communication Port) controls the communication between ARM core and DSP core.
CSROMEN, CSRAMEN and CS1N to CS4N in the ARM core are connected to each memory. WEN and OEN control the
process of memory. External IRQ(Interrupt ReQuest) signals from each units, such as, YMU, Ear-jack, Ear-mic and
CSP1093, need the compatible process.
Some PPI pins has many special functions. CP_KB[0~9] receive the status from key FPCB and are used for the
communications using data link cable(DEBUG_DTR/RTS/TXD/RXD/CTS/DSR).
And UP_CS/SCLK/SDI, control signals for CSP2200 are outputted through PPI pins. It has signal port for
charging(CHG_DET), SIM_RESET and FLIP_SNS with which we knows open.closed status of folder. It has JTAG control
pins(TDI/TDO/TCK) for ARM core and DSP core. It recieves 13MHz clock in CKI pin from external TCXO and receives
32.768KHz clock from X1RTC. ADC(Analog to Digital Convertor) part receives the status of temperature, battery type and
battery voltage. And control signals(DSP_INT, DSP_IO and DSP_RWN) for DSP core are used. It enables main LCD with
DSP IP pins.