installing your dryer
_15
INSTALLATION STACKING
1.
Carefully lay the dryer on its side. Use the packing material
so you don’t scratch the finish on the dryer.
2.
Install rubber pads to dryer base.
• Locate the 4 rubber pads in the parts package. Insert
the rubber pads into the holes at the bottom of the
leveling legs.
• Purchase the stacking-kit package additionally.
3.
Set the dryer upright.
The stacking kit can only be installed for Samsung family products.
4.
Install bracket to dryer.
• Remove washer top cap screw from the rearleft.
Align left bracket holes with top cap screw hole on
rear left of the unit and replace screw.
Leave screw loose so dryer hole alignment will be easier.
• Repeat the above step with the right side.
5. Install dryer and bracket on washer
• Lift the dryer on top of the washer. Protect the washer control panel with cardboard or
other protection. Be sure to lift the dryer high enough to
clear the washer control panel.
Personal Injury. More than two people are
recommended to lift the dryer into position because of
its weight and size. Failure to do so could result in injury.
• Align the holes in the bracket with the holes in the back
of the dryer.Using a Phillips screwdriver, attach the
M4x12 tapping screws.
• Tighten the washer bracket screws ; then tighten all
stacking kit screws.
6.
Finalise the installation
• Refer to the washer Installation Instructions to
complete the washer installation.
• Refer to the dryer Installation Instructions to complete
the dryer installation.
• Carefully slide or walk the stacked washer and dryer
into place. Use felt pads or other sliding device to
assist moving and to protect flooring.
Do not push on the dryer once installed to top of the
washer. Pushing on the dryer may result in pinched
fingers.
01
INST
ALLING YOUR
DR
YER
Bracket-Stacking
WARNING
Screw
CAUTION
Dryer
Washer
WARNING
SDC16809-02885A_EN.indd 15
2010-07-09 ¿ÀÈÄ 2:20:21
