SAMSUNG Proprietary - Contents may change without notice
5-7
3. CDMA
TEST ITEMS PROCEDURE
1. PREPARANCE
Set test equipments up.
"* 7 5 9 # 8 1 3 5 8 0" : Enter the Test Mode
"0 1" : Suspend
"0 4" : Current Mode Check
Conf irm that the phone is in the "CDMA Mode".
(If not CDMA Mode, Use Test Command "21""2XXXX" and Push
the Navigation Key to "OK", and enter "0 2" to restart)
If you select a wrong key, press "#", then enter new command.
To exit the Test Mode at any time, just press [0 2].
2. FREQUENCY
"0 1" : Suspend.
ACCURACY
"0 9 0 3 6 3 #" : Set channel to 363.
"0 7" : Carrier On.
"7 3" : ON/OFF of Tx drive Amp.
In case of Tx PWR output bellow - 6dBm, set to "0".
In case of Tx PWR output above - 6dBm, set to "1".
"7 1 3 6 0 #" : Set AGC level.
Measure the TX f requency : 835.89MHz°æ300Hz.
3. OCCUPIED CDMA
"0 1" : Suspend.
BANDWIDTH
"0 9 0 3 6 3 #" : Set channel to 363.
"0 7" : Carrier On.
"3 4" : Spread spectrum.
"7 3" : ON/OFF of Tx drive Amp.
In case of Tx PWR output bellow - 6dBm, set to "0".
In case of Tx PWR output above - 6dBm, set to "1".
"7 1 X X X #" : Enter AGC Code(XXX) to adjust RF Output Power.
Measure the bandwidth (spec: 1.32MHz).
4. LIMITATIONS ON
"0 1" : Suspend.
EMISSIONS
"0 9 0 3 6 3 #" : Set channel to 363.
"0 7" : Carrier On.
"7 3" : ON/OFF of Tx drive Amp.
In case of Tx PWR output bellow - 6dBm, set to "0".
In case of Tx PWR output above - 6dBm, set to "1".
"3 4" : Spread spectrum.
"7 1 X X X #" : Enter AGC Code(XXX) to adjust RF Output Power.
Measure the spurious at FC ±900kHz, FC ±1.98MHz, 2FC, 3FC, 1/2FC.
spec: FC ±900kHz below 42dBc/30kHz
FC ±1.98MHz below 54dBc/30kHz
Outside Receive Band 43+10log (PY)
PY: Mean Output Power in watts.
