Samsung Electronics
6-15
Command No.
Signal. Name
Description
(OP, AB, RB)
42(AA, 1, 0)
T_DTMFON_I
2)
Activate DTMF generator with keycode.
43(AB, 0, 0)
T_DTMFOFF_I
Deactivate DTMF generator.
44(B0, 0, 0)
T_COMPANDORON_I
Enable the compressor and expandor.
45(B1, 0, 0)
T_COMPANDOROFF_I
Disable the compressor and expandor.
46(B2, 0, 0)
T_AMPS_VCLINE_I*
Enter Analog voice channel state.
47(B3, 3, 0)
T_AMPS_AUD_GAIN_I
FM audio gain.
48(B4, 0, 0)
T_VIBRATOR_ON_I
Activate a vibrator.
49(B5, 0, 0)
T_VIBRATOR_OFF_I
Deactivate a vibrator.
50(B6, 0, 4)
T_BATT_TYPE_I
Battery type.
51(B7, 1, 1)
T_BBA_I
BASIC supplier
52(B9, 2, 2)
T_HW_VERSION_I
HW version
57(BC, 0, 0)
T_MIC_ON_I
Mic path on.
58(BD, 0, 0)
T_MIC_OFF_I
Mic path off.
59(BE, 0, 0)
T_ALLPATH_I
Set RX Path, TX path Unmute to Earpiece.
60(BF, 3, 0)
T_AMPS_TX_GAIN_I
2)3)
AMPS TX Audio Gain Control.
61(C0, 3, 0)
T_AMPS_RX_GAIN_I
2)3)
AMPS RX Audio Gain Control.
62(C1, 3, 0)
T_DTMF_VOL_TX_I
2)3)
AMPS TX DTMF Gain Control.
63(C2, 3, 0)
T_TX_LIMITER_I
2)3)
AMPS TX Limiter Gain Control.
64(C3, 3, 0)
T_AMPS_SAT_LEVEL_I
2)3)
AMPS TX SAT level Control.
65(C4, 3, 0)
T_AMPS_FREQ_SGAIN_I
2)3)
AMPS TX Master Gain Control.
66(C5, 3, 0)
T_AMPS_ST_GAIN_I
2)3)
AMPS TX ST Gain Control.
67(C6, 3, 6)
T_READ_BATT_I
1)
Read low batt in the standby, talk mode.
68(C8, 0, 3)
T_VBATT1_I
3)
Set the low battery position in the standby.
69(C9, 0, 3)
T_VBATT2_I
3)
Set the low battery position in the talking.
70(CA, 3, 0)
T_WRITE_BATT_I
3)3)
Write low battery Level Value to NVM.
71(D1, 3, 0)
T_CDMA_TXADJ_I
2)
Change pdm TX AGC in CDMA.
72(D2, 3, 0)
T_AMPS_TXADJ_I
2)
Change pdm TX AGC in AMPS.
73(D3, 1, 0)
T_SET_PA_R_I
2)
Set PA R1, R0 in CDMA.
74(D4, 4, 0)
T_TXRAS_ADJ_I
TX Ras table adjust.
75(D5, 0, 3)
T_READ_RSSI_I
3)
Read a RSSI.
Circuit Description
Summary of Contents for SCH-1500 series
