English
_17
●
in
St
aLL
ation & connection
connecting to the monitor
Connect the video out port of the camera to the video input port of the monitor.
M
`
To check the display screen after installing the camera for the first time, you can use the Video
port to check the video screen.
`
You can set the video output type to either NTSC or PAL. (page 31)
`
The C-Video source (4:3) will be displayed with either side truncated in comparison with the
HD-SDI video.
`
The video source from the HD-SDI port can be displayed on the dedicated monitor. To display the
source on a commercial monitor, you need a converter to convert the video signal as appropriate.
video cable
The cable connecting the camera’s video output and a monitor is a BNC coaxial cable as
shown below.
If the distance between the camera and the monitor exceeds the recommended maximum,
please us an auxiliary video amp.
Maximum video transfer
distance
Recommended cable
specification
100~140m
5C2V(75ohm)
200m
L-6CHD(75ohm)
(SDI-specific Cable)
rS-485 communications
Using RS-485 communication, the camera menu can be accessed using Samsung
Techwin’s System Controller or the DVR.
•
for accessing the camera from a computer
Use a RS-485 converter to connect the camera’s control port with the computer’s
serial cable.
Ex) Serial port (COM1) of computer
Serial Cable
RS-485 Converter
Camera’s
RS-485 control port
•
for accessing the camera from a Dvr or the System controller
connect the camera’s RS-485+ and RS-485– terminals to the RS-485 control board’s
terminals of desired device with a RS-485 cable (TRX+ and TRX–).
Control ports of RS-485 Controller
RS-485 ports of the camera
(+) CONNECTION TERMINAL (TRX+)
485+
(–) CONNECTION TERMINAL (TRX–)
485–