●
IN
s
TA
ll
ATION
English_13
3) Place the separated ceiling bracket so that the “Front” side faces the area to be monitored and install it
with the M4 tapping screws(see Figure-1).
4) If a hole has been drilled on the bracket installation surface for cable access, press down to remove
the Cable Stopper and attach the provided dustproof plate to it (Figure-2), and arrange the cables
through
the
plate.
The dust-proof plate is to prevent outside dust from inflow to the wiring compartment.
5) Now attach the Main body to the Mount bracket by rotating it in the LOCK direction after aligningthe
Groove mark on the Main body with the wide groove around the CAMERA FRONT inlay.(Figure-3)
6) Adjust the camera lens to face the area to be monitored.
7) Finally attach the Cover dome to the Main body by pressing it until a “click” sound is heard after aligning
the bump inside the Cover dome with the groove mark on the Main body.
• The installation should be done by qualified service personnel or
system installers.
• If the ceiling material is not strong enough to hold the installation
screws, the camera may fall off. Reinforce the ceiling as needed.
• To change the position of the cable, take away the Hole Cover,
attach the provided dustproof plate and pass the cable through.
Notes
Original position of
the cable
Wiring Cover
Figure-1
Figure-2
Figure-3
SCD-1080_ENG.indd 13
2012-8-27 10:33:03