Samsung SCC-B539X, User Manual, Page: 10 / 66

10 11
Set the LL switch to ON while the AC
power is connected. If any picture roll
happens, you have to adjust the phase
using the phase-control buttons. Press
the INC or DEC button to increase or
decrease the phase by one degree.
2. Switch 2 (LSS) : This sens-up mode
accumulates the image fields in
memory to reduce noise but increase
the brightness and contrast rate. When
this switch is set to ON , the camera
automatically switches to a maximum
of 128 times of image acquisition speed
to implement a clear picture for darker
image.
3. Switch 3 (H-REV) : When this switch is
set to ON , the camera image is reversed
horizontally. If you want to monitor your
site using a mirror, you can use this
feature to see the right image.
4. Switch 4 (V-REV) : When this switch is
set to ON , the camera image is reversed
vertically. If your camera reluctantly
displays the vertically reversed image,
you can use this feature to see the right
image.
5. Switch 5 (BLC) : When this switch is set
to ON , you can view a clear image even
though the camera faces any excessive
light such as sunlight and fluorescent
light. When it is set to OFF , the subject
with excessive light is not clearly shown.
6. Switch 6 (FL) : When this switch is set
to ON, the shutter speed is fixed to
1/100 sec (for NTSC) or 1/120 sec (for
PAL) to prevent screen from flickering
by the disaccordance between vertical
synchronous frequency (50Hz for NTSC,
60Hz for PAL) and on-and-off frequency
of a light.
7. Switch 7 (D/N) : When this switch is set
to
ON
, the camera automatically switches
between color and B&W according to the
brightness of the vicinity.
8. Switch 8 (AWB) : This switch adjusts
white balancing. When this switch is set to
ON , this camera operates in ATW mode,
and in case of OFF , this camera operates
in AWC mode.

ATW (Auto Tracking White Balance):
The color temperature is automatically
adjusted according to the environmental
change. (Approx. 2000°K to 11,000°K)

AWC (Auto White Balance Control): It
stores the color temperature just when
the switch is changed to OFF . Accordingly
color temperatures are adjusted by the
stored value.
Caution
-. The IRIS setting range for the camera is
approximately 80 to 120 IRE. It means
the camera does not provide the IRIS
full open/close feature but the restricted
variation range.
-. Use the camera after setting to the proper
level (80 IRE or above) because the IRIS
hunting may occur when the level is 75
IRE or below.
AB68-00649E(01)Eng.indd 10 2007-05-14 ｿﾀﾈﾄ 7:55:52