35
Operating Instructions
Operating Instructions
34
- Move the selection cursor of the LINE LOCK
MENU to “V-PHASE” and adjust the line lock of
the camera by using right/left direction switch.
8) VIDEO CON MODE
Move the cursor to “VIDEO CON” and select the
“FIX/MANU---” using right/left direction
switch. When “FIX” is selected, the conditions at
the time of shipment are set.
When “MANU---” is selected, H-DTL, V-DTL,
posi/nega of the video signal can be changed by
the user on VIDEO CONTROL SUB MENU.
(LINE LOCK)
V-PHASE (00)
RET
----
----
(SET UP)
OFF
OFF
ALC---
OFF
ON
ATW
INT
MANU---
OFF
QUIT?
CAMERA ID
SENSE UP
ALC/ELC
BLC
AGC
WHITE BAL
SYNC
VIDEO CON
MOTION DET
EXIT
Setting the VIDEO CONTROL MENU
- Setting RS485 ADDR (refer to the diagram below)
Move the cursor to “RS 485 ADDR” and select the
“0~255” using right/left direction switch. (0~255: the
number of cameras that can be used). When a
multiple number of cameras is used, Address to
control each camera should be set using RS485
communications.
- Adjusting H-DTL (refer to the diagram on page 36)
Move the cursor to “H-DTL” (horizontal edge
adjustment) and change the value using the right/left
direction switch. The value can or – starting
from 0 using the right/left direction switch.
- Adjusting V-DTL (refer to the diagram on page 36)
Move the cursor to “V-DTL” (vertical edge
adjustment) and change the value using the right/ left
direction switch. The value can or – starting
from “0” using the right/left direction switch.
- Setting POSI/NEGA (refer to the diagram on page 36)
Move the cursor to “POSI/NEGA” and select
“POSI/NEGA” using the right/left direction switch.
When “POSI” is selected, video signals (Y, Chroma
signal) are generated in a normal way.
When “NEGA” is selected, video signals (Y, Chroma
signal) are generated in the opposite way.
(Often used when imaging film.)
Note: When using Video Al lens, normal operation is
not made even when “NEGA” is set.
00107A SCC-833P/855P - gb 11/22/00 3:36 PM Page 34