English - 17
SETTING
UP
When moving your refrigerator
To prevent floor damage, be sure the front
adjusting legs are in the up position (above
the floor).
Refer to “Leveling the Refrigerator” on
page 20.
Flat-blade screw
driver (-)
Control Lever
Flooring
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
CAUTION
REMOVING THE REFRIGERATOR
DOORS
For some installations, you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location.
Do not remove the doors/drawer if you don’t need
to.
If you do not need to remove the refrigerator
doors, go to “Leveling the Refrigerator” on page
20.
If you need to remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
Disconnect power to the refrigerator
before removing the door or drawer.
• Be careful not to drop, damage or
scratch the door / drawer while removing
them.
• Be careful not to injure yourself while removing
the doors / drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassembling the refrigerator doors
Be careful not to drop and scratch the
doors while removing them.
WARNING
WARNING
DA68-02954H (EN)-03-���.indd 17
2018. 2. 1. �� 3:48
