setup screen
40_ setup screen
nAS (network Attached Storage) guide
J
`
Since data may not be saved after a temporary network interruption when using NAS, it is recommended that you use SD at
the same time to prevent loss of recorded images.
`
If the setting allows a Micro SD memory card and the NAS to be simultaneously connected for use, the higher priority for
recording goes to the NAS.
`
If you activate Overwrite to the NAS by setting it to <
Off
> and the available capacity is below 1%, it will be saved in the Micro
SD card.
`
If you are saving data in the NAS, you might be unable to save it when you insert a Micro SD memory card used by another
camera.
`
NAS recommended specs : Refer to “
NAS recommended specs
”. (Page 7)
`
If you change the NAS saving while saving data in the NAS, it will not be reflected in the system immediately.
`
If you remove NAS equipment on your own while saving data, or if the network is disconnected, NAS saving operation will be
terminated abnormally.
`
NAS saving allows only one camera to a folder. Logging in with another camera is not allowed, and the images will not be
saved.
The following is a description of how to save data using the NAS according to the Synology NAS method,
which is one of the recommended products.
1.
Access the Synology NAS as an admin.
In this example, the NAS IP Address is set to
[
192.168.20.253
].
2.
If you access it as an admin, the following screen will be
displayed. Click the [
Control panel
].
3.
Click the <
Shared folder
> in the file sharing and privilege
menu.
4.
Click the [
Create
] button.
5.
After entering the shared folder name(ID), click the [
oK
]
button to create a shared folder.
In this example, the shared folder name is [
testDirectory
].
6.
In Windows, for NAS access, set the privilege for the shared
folder as follows.
Check the admin’s [
read/write
].
7.
Click on the <
user
> in the file sharing and privilege menu.
8.
After clicking the [
Create
] button, enter name(ID) and
password.
In this example, name(ID) is set to [
testiD
] and password is
also set to [
testiD
].
J
`
Netgear’s NAS equipment will only operate with ReadyNAS OS
version 6 or higher (device version 6.x.x).
`
According to the NAS recommendations, when you use Netgear’s
NAS equipment, do not allocate the capacity for use.
9.
In Windows, set the privilege for NAS access.
For the shared folder created in step 4 called “testDirectory”
check [
read/write
].