3
.2
C
HAPTER
T
HREE
: O
PERATION
O
P E R AT I O N
4
While “Red” is highlighted (letters are
blue color), press the
VOL+
button: A
crosshair pattern will appear on the
screen. If either a vertical or a
horizontal red line is visible, then the
convergence needs alignment.
5
If a horizontal red line is
visible, use
CH
▲
and
CH
▼
buttons
to move the line so that it is super-
imposed on the horizontal center-
line (i.e., make a single horizontal
line that is as white as possible.)
6
If a vertical red line is visible, use
the
VOL +
and
VOL -
buttons to
move the line so that it is superim-
posed on vertical-center line (i.e.,
make a single vertical line that is as
white as possible.)
Adjust Red Convergence
7
If the left adjustments need, press the
number(4) button on the remote control
to move the vertical red line to the left.
Use the
VOL
+/-
to buttons to move the
line to the right or left.
If the right adjustments need, press the
number(6) button on the remote control
to move the vertical red line to the right.
Use the
VOL
+/-
to buttons to move the
line to the right or left.
To do Left or Right Convergence
(Except model HCJ652W)
8
After the red convergence is correctly adjusted, press
MENU
four times
to exit all the menus.
▼
Note: While the left and
right adjustments are done, the
CH
▲
and
CH
▼
buttons will not
work.
•For ‘Blue’ adjustment, do the same as the above.
00578C(E)-CHAPTER 3 7/3/00 4:40 PM Page 2
