Samsung OfficeServ500, Installation Manual

Page: 101 / 132

8-1
Chapter 8 Connecting Optional Equipment
Optional equipment covered in this chapter includes:
z Music-On-Hold/Background Music
z External Paging
z Ring Over Page
z Printer for SMDR/UCD/traffic/alarm reports
z Common Bell
z PC for programming
z Voice Mail/Auto Attendant (customer-provided)
(For full details of MMC programming for these options, see the Samsung Combined Systems
Programming Manual .)
Music On Hold/Background Music
Connect each customer-provided music source to the music input on a MISC daughter-
board ( Figure 8-1 ).
Each C.O. line (trunk) can be programmed to receive a music source, system-generated
tone or ‘NO MUSIC’ when it is put on hold. Each keyset can receive a music source or
‘NO MUSIC’ for background music.
External Paging
Each MISC daughterboard provides a voice pair and a dry contact pair to be used with cus-
tomer-provided paging equipment. Connect the customer-provided paging equipment to the
page output pins of a MISC daughterboard (
Figure 8-2 ). The relay must be assigned to the page
zone in MMC 605.
The page voice pair is 600 Ohm impedance. If the amplifier page input is not 600 Ohm, use an
impedance matching transformer. The paging contact pairs are for control of low voltage circuits
or amplifier output. The contacts are rated at 24 VDC–1 amp.
WARNING: Do not attempt to connect commercial AC power to these contacts.