OfficeServ 7100
INSTALLATION
TECHNICAL MANUAL
PART 3 MAY 2010
3.15
The front view of the UNI card is shown in the picture below.
Figure 3.14 Front View of UNI Card
Table 3.4 UNI Card Ports and LEDs
Port, LED
Function Description
MD1 P1~P4
MD2 P1~P4
MD3 P1~P4
Ports that correspond with the daughtercard modules installed in the
specific MD1, MD2 and MD3 connectors on the UNI card.
MD(1~3) LEDs
Shows the status of each daughterboard connector (MD1, MD2, and
MD3) on the UNI card:
- Off: No module mounted
- On (Green): TRM mounted.
- On (Red): DLM mounted.
- On (Amber): SLM mounted.
3.4 DAUGHTERCARD MODULES
There are 5 different daughtercards available on the OfficeServ 7100:
1)
4SWM
(installed on MP10/MP10a only): 4 port PoE layer 2 LAN switch.
2)
Modem Daughtercard
(Installed on MP10/MP10a only): Provides modem
communication for the OfficeServ 7100 system.
3)
4TRM
(installed on UNI card only): 4 port loop start trunk interface module.
4)
4DLM
(installed on UNI card or MP10/MP10a): 4 port digital phone interface module.
5)
4SLM
(installed on UNI card only): 4 port Single Line Analog telephone interface.
3.4.1 4SWM (4 Port PoE LAN Switch Daughtercard)
THIS DAUGHTERCARD CAN ONLY BE INSTALLED ON THE MP10/MP10a MAIN PROCESSOR BOARD
to Section 3.2.3 “Installing the MP10/MP10a”
). This daughtercard CANNOT be installed on the
UNI card. Only one 4SWM can be mounted per system. The 4SWM is a 4 port LAN Switch that
Home Page
Table of Contents
Home Page
Table of Contents
