38 English
Maint
enanc
e
Maintenance
Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
1
2
3
LL
C
C
R
R
1.
Remove the center burner griddle(C)
following both sides grates.(L/R)
2.
Remove the burner caps from the burner
heads.
3.
Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4.
Clean all removable grates, griddle and
burner components in warm, soapy
water. Do not use steel-wool pads or
abrasive cleaners.
5.
Rinse and dry grates, griddle and burner
components thoroughly.
8
7
6
6.
Return the burner heads to their
positions on top of the manifold valves.
Make sure a starter electrode is inserted
through the hole in each burner head.
NOTE
See the next page for detailed burner
component re-assembly instructions.
7.
Return the burner caps to their positions
on top of the burner heads. To ensure
proper and safe operation, make sure the
burner caps lie flat on top of the burner
heads.
8.
Reinstall the burner grates and griddle in
their respective positions.
9.
Turn on each burner and check if it
operates properly. After verifying that a
burner operates normally, turn it off.
NOTE
•
After cleaning, confirm that the burner port openings aren't plugged.
•
Shake out any excess water and then let burner heads and caps dry thoroughly.
Placing the center burner upside down will allow the water to drain out more
easily.
•
Do not wash any burner components in a dish washer.
CAUTION
•
The starter electrodes are not removable. Do not attempt to remove them by
force.
•
To avoid chipping, do not bang grates and caps against each other or against
hard surfaces, such as cast iron cookware.
•
The burner head can be blocked by food or dust. Clean the head if it appears
blocked. If you clean the head with water, assemble it only after it is completely
dry. If the head is wet, it might prevent the burners from igniting.
•
To avoid falling down the grates, make sure to remove both sides grates first.
•
Do not attempt to remove center oval burner cap from the head.
Burner reinstall guide
Round burner head
1.
Orient the burner head so that the
opening for the electrode lines up with
the electrode.