24
3. Disassembly and Reassembly
3-9 Removing the Chassis Manifold Panel, Knob, Switch Ignition
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range . Replace all panels before operating the range . Failure to do
so can result in death or electrical shock .
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off the gas supply to the range before servicing. Check all gas lines and fittings for leaks before
operating the range . Replace all panels before operating the range . Failure to do so can result in death or
personal injury from explosion, fire, or asphyxiation.
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be present,
and you can cut yourself if you are not careful .
Parts
Explanation Photo
Explanation
Knob
Pull the control knob straight off
1.
Turn off the electrical supply
going to the range .
2.
Shut off the gas shut-off valve
in the gas supply line to the
range .
3.
Open the door or Remove it .
4.
Pull burner control knobs
straight off to remove them
from the valve shafts .
Chassis
Manifold Panel
Screws from the bottom
5.
Remove 2 screws from the top,
2 screws from the front and 4
screws from the bottom of the
chassis manifold panel .
6.
Remove the chassis manifold
panel from the front of the
range .
Switch Ignition
Connector
Switch ignition
7.
Place
a finger behind each side
of the switch ignition and pull
it straight out to release it from
the control shaft . Repeat for
each switch .
8.
Disconnect the wires at the
connectors .
