20 English
Maint
enanc
e
Maintenance
Racks
To keep the racks clean, remove them from the cavity, and soak them in lukewarm
soapy water. Then, scour impurities off the racks using a plastic scouring pad. If the
racks do not slide in and out smoothly after you have cleaned them, rub the side
rail guides with wax paper or a cloth containing a few drops of cooking oil. This
will help the racks glide more easily on their tracks.
NOTES
•
Do not use a dishwasher to clean the racks.
•
If a rack does not slide in and out smoothly, apply a few drops of cooking oil to
the oven rack guides.
•
If a rack becomes too difficult to slide in or out, lubricate the rack.
•
To purchase the graphite lubricant, contact us at 1-800-SAMSUNG (726-7864).
•
For online shopping, visit http://www.samsungparts.com/Default.aspx and search
for part DG81-01629A.
Oven
•
Wear the glove during cleaning.
Maintenance
Cleaning
CAUTION
Wear the glove during cleaning.
Control panel
First, lock the control panel to prevent accidental operations and/or product
tipping.
1.
Press and hold the
START/SET
button for 3 seconds to lock the control panel.
2.
Clean the control panel using a soft cloth dampened with plain water, warm
soapy water, or glass cleaner. Do not spray cleansers directly onto the control
panel.
3.
When done, press and hold the
START/SET
button again for 3 seconds.
WARNING
•
Make sure the control panel turns off and all surfaces of the gas oven are cool
before cleaning. Otherwise, you can get burned.
•
If the gas oven has been moved away from the wall, make sure the anti-tip
device is reinstalled properly when the gas oven has been put into place again.
Otherwise, the gas oven may tip over, causing physical injuries.
•
Do not use steel-wool or abrasive cleansers of any kind. These can scratch or
damage the surface.
Stainless steel surface
1.
Remove any spills, spots, and grease stains using a soft, wet cloth.
2.
Apply an approved stainless steel cleanser to a cloth or paper towel.
3.
Clean one small area at a time, rubbing with the grain of the stainless steel if
applicable.
4.
When done, dry the surface using a soft, dry cloth.
5.
Repeat steps 2 through 4 as many times as necessary.
CAUTION
•
Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces. It
will scratch the surface.
•
Do not spray any type of cleanser into the manifold holes. The ignition system is
located in those holes and must be kept free of moisture.
