17
Step-by-step installation guide
NOTE
: When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet. Keep
it tight throughout Steps 1-3. Do not pinch cord or lift
oven by pulling cord.
1
. Lift microwave, tilt it forward,
and hook slots at back
bottom edge onto four lower
tabs of mounting plate.
2
. Rotate front of
oven up against
cabinet bottom.
3
. Insert a self-aligning screw through the top center
cabinet hole. Temporarily secure the oven by turning
the screw at least
two full turns
after the threads
have engaged. (It will be completely tightened later.)
Be sure to keep power cord tight. Be careful not
to pinch the cord, especially when mounting
flush to bottom of cabinet.
Cabinet Front
Filler Block
Microwave Oven Top
Self-Aligning Screw
Equivalent to
Depth of
Cabinet Recess
Cabinet Bottom Shelf
Equivalent to
Depth of Cabinet
Recess
Cabinet Bottom Shelf
Microwave Oven Top
Cabinet Front
Filler Block
Self-Aligning Screw
4
. Attach the microwave oven to the top cabinet.
5
. Insert 2 self-aligning screws
through outer top cabinet holes.
Turn two full turns on each screw.
6
. Tighten center
screw completely.
7
. Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold the
microwave oven in place against the wall and the top
cabinet.)
8
. Install grease filter. See the Owner’s Manual packed
with the microwave.
B5. INSTALLING THE CHARCOAL FILTER
1
. Remove screws on top of grille using a #1 Phillips
screwdriver.
2
. Open the door.
3
. Remove the grill.
• After push left, Pull the straight off.
Charcoal filter
4
. Install the charocal filter. When properly installed,
the wire mesh of the filter should be visible from the
front.
5
. Reinstall the grille and the screws.
6
. Close the door.
Insert mesh-side up
OTR_II_DE68-03587B-07_EN+CFR.indb 17
OTR_II_DE68-03587B-07_EN+CFR.indb 17
2022-01-20 �� 10:11:55
2022-01-20 �� 10:11:55
