10
Step-by-step installation guide
D. ALIGNING THE WALL PLATE
CL
CAUTION:
Wear gloves to avoid cutting
fingers on sharp edges.
Area E
Hole B
Hole A
Centerline
notches
Draw a Vertical Line
on Wall from Center
of Top Cabinet
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Horizontal Line
Horizontal Line
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Draw a Vertical Line
on Wall from Center of
Top Cabinet
Horizontal Line
Horizontal Line
Area E
Centerline
notches
Hole A
Hole B
CAUTION
: Wear gloves to avoid cutting fingers on
sharp edges.
1
. Draw a Vertical line on the wall at the center of
the 30˝ wide space.
2
. Draw a Horizontal line on the wall at the bottom
of the “Rear Wall Template”.
3
. Drill ⅝˝ holes for toggle bolts on 3 locations
(Hole A, Hole B, Hole C) but if the location of hole
is same as that of stud, drill a
3
/
16
˝ hole for wood
screw. In other words, toggle bolt can not be
used to the location of stud.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
NOTE
: Holes A, B and C are inside area E. If none
of A, B and C is in a stud, find a stud somewhere
in area E and draw a forth circle to line up with the
stud. It is important to use
at least one wood
screw
mounted
firmly in a stud
to support the
weight of the microwave.
Set the mounting plate
aside.
OTR_II_DE68-03587B-07_EN+CFR.indb 10
OTR_II_DE68-03587B-07_EN+CFR.indb 10
2022-01-20 �� 10:11:53
2022-01-20 �� 10:11:53
