The mains lead is attached to the rear of your set.
1.
Plug the mains lead into an appropriate socket.
The standby indicator lights up on the front of the set.
2.
Press the
button on the front of the set.
You also can press the
POWER
button or the
TV
( ) button on the remote control to turn the TV on.
The programme that you were watching last is reselected automatically.
3.
Press the numeric button (0~9) or channel up/down (
/
) button on the remote control or
button on the right side of the panel.
When you switch the set on for the very first time, you will be asked to choose language in which the menus
are to be displayed.
4.
To switch your set off, press the
POWER
button again.
Your set can be placed in standby mode in order to reduce the power consumption. The standby
mode can be useful when you wish to interrupt viewing temporarily (during a meal, for example).
1.
Press the
POWER
button on the remote control.
The screen is turned off and a standby indicator appears on the front of your set.
2.
To switch your set back on, simply press the
POWER
, numeric buttons
(0~9)
or channel
up/down (
/
) button again.
Do not leave your set in standby mode for long periods of time (when you are away on holiday, for example).
It is best to unplug the set from the mains and aerial.
When the TV is initially powered on, several basic settings proceed
automatically and subsequently. The following settings are available.
1.
Press the
POWER
button on the remote control.
The message “Start Plug & Play” is displayed with “OK” selected.
Press the
ENTER
button.
2.
Select the appropriate language by pressing the
or
button.
Press the
ENTER
button to confirm your choice.
3.
The message “Check antenna input.” is displayed with “OK” selected.
Press the
ENTER
button.
Please check that the antenna or cable TV is connected correctly.
English-6
1.
Lift the cover at the back of the remote control upward as shown in the figure.
2.
Install two AAA size batteries.
Make sure to match the “+” and “–” ends of the batteries with the diagram inside the compartment.
3.
Replace the cover.
Remove the batteries and store them in a cool, dry place if you won’t be using the
remote control for a long time. The remote control can be used up to about 23 feet from
the TV. (Assuming typical TV usage, the batteries last for about one year.)
If the remote control doesn’t work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
Installing Batteries in the Remote Control
Switching On and Off
Placing Your Television in Standby Mode
Plug & Play
BN68-000000-00Eng.qxd 9/1/06 11:45 AM Page 6
