11
Connecting to cabinets
Connect the S-Box (SNOW-1810U) and the cabinet (IW008J) to the installed cabinet for video
signal transmission.
"
Connect the S-Box to the external device before connecting the S-Box to the cabinet.
"
Before connecting power to the cabinets, connect the I/G card to the cabinets first.
"
Connect only one type of LED pitch cabinets to a single S-Box. Normal picture quality may
not be obtained if different types of cabinets are connected. Do NOT use different types of
LED pitch cabinets together.
S-Box
(SNOW-1810U)
HDBT OUT
HDBT IN
DATA OUT (Forward)
DATA IN
DATA OUT
DATA IN (Reverse)
DATA IN
DATA OUT
First cabinet
(IW008J)
Connecting cables for redundancy
Last cabinet
(IW008J)
I/G Card
1
Connect the HDBT terminals on the S-Box and I/G cards using a LAN cable.
2
Connect I/G cards and cabinets using OCM cables.
"
Use a cable of CAT 6 (*STP type) or higher.
*STP: Shielded Twisted Pair
"
Connect the HDBT by using a LAN cable that is 15–100 m in length. If you use a cable that is
out of specified length range, the signal quality may be unstable.
"
Use the LAN cables recommended on the HDBaseT website (http://hdbaset.org/hdbaset-
recommended-cables). If a LAN cable that is not recommended is used, the HDBT signals
may become unstable.
Supported resolutions per installation
Resolution
960 x 540
1920 x 1080
3840 x 2160
Quantity of cabinets
1
2 x 2
4 x 4
"
One S-Box (SNOW-1810U) supports up to UHD resolution because it has four built-in
HDBT
OUT
ports.
"
To enjoy resolutions that exceed UHD resolution, you need to add S-Box (SNOW-1810U) to
the configuration.
