Samsung iES4028F, Management Manual

Page: 403 / 712

System Management Commands
4-67
4
clock timezone-predefined
This command uses predefined time zone configurations to set the time zone for the
switch’s internal clock. Use the
no form to restore the default.
Syntax
clock timezone-predefined offset - city
no clock timezone-predefined
• offset - Select the offset from GMT. (Range: GMT-0100 - GMT-1200;
GMT-Greenwich-Mean-Time; GMT+0100 - GMT+1400)
• city - Select the city associated with the chosen GMT offset. After the offset
has been entered, use the tab-complete function to display the available
city options.
Default Setting
GMT-Greenwich-Mean-Time-Dublin,Edinburgh,Lisbon,London
Command Mode
Global Configuration
Command Usage
This command sets the local time zone relative to the Coordinated Universal
Time (UTC, formerly Greenwich Mean Time or GMT), based on the earth’s
prime meridian, zero degrees longitude. To display a time corresponding to
your local time, you must indicate the number of hours and minutes your time
zone is east (before) or west (after) of UTC.
Example
Related Commands
show sntp (4-62)
clock timezone
This command sets the time zone for the switch’s internal clock.
Syntax
clock timezone name hour hours minute minutes { before-utc | after-utc }
• name - Name of timezone, usually an acronym. (Range: 1-29 characters)
• hours - Number of hours before/after UTC. (Range: 0-12 hours before;
0-13 hours after)
• minutes - Number of minutes before/after UTC. (Range: 0-59 minutes)
• before-utc - Sets the local time zone before (east) of UTC.
• after-utc - Sets the local time zone after (west) of UTC.
Console(config)#clock timezone-predefined GMT-0930-Taiohae
Console(config)#