16
CONNECTIONS
●
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
●
If the main unit is powered off, the wireless subwoofer will in standy mode and the STANDBY LED on the
front will blink Red directly. (no blue LED).
●
If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar,
interference may cause some sound interruption.
●
The maximum transmission distance of the wireless signal between the main unit and subwoofer is about
10 meters, but may vary depending on your operating environment. If a steel-concrete or metallic wall is
between the main unit and the wireless subwoofer, the system may not operate at all, because the wireless
signal cannot penetrate metal.
●
If the main unit doesn't make a wireless connection, follow steps 1-5 on the previous page to re-set the
connection between the main unit and wireless subwoofer.
●
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and
moisture.
●
For optimal listening performance, make sure that the area around the wireless subwoofer location is clear
of any obstructions.
CONNECTING THE SWA-8000S
(SOLD SEPARATELY)
●
Expand to true wireless surround sound by connecting the Samsung Wireless Rear Speaker Kit
(SWA-8000S) to your Soundbar. (Sold separately)
●
Before connecting to the Wireless Receiver Module, connect your subwoofer first.
●
Use the speaker cable to connect the wireless receiver module to the speakers.
●
Plug the power cable into a power outlet. The LED turns on.
1.
While the main unit is powered off (in STANDBY mode), press and hold the (Mute) on the remote control for
5 seconds.
2.
The
ID SET
message appears on the Soundbar's display.
3.
Plug the power cord of the Wireless Receiver Module (SWA-8000S) into an AC wall outlet.
4.
Turn on your Soundbar when the link indicator (Blue LED) on the SWA-8000S flickers fast.
5.
When the link indicators (Blue LEDs) on your subwoofer and the SWA-8000S flash and then glow continuously, the
SWA-8000S is completely connected.
●
This may take a few minutes.
●
Once connected, your Soundbar and the Wireless Receiver Module are automatically reconnected even
after you turned them off and then on.
