![background image](http://html.mh-extra.com/html/samsung/gt-e1081/gt-e1081_service-manual_1192299041.webp)
SAMSUNG Proprietary-Contents may change without notice
Exploded View and Parts List
11-4
This Document can not be used without Samsung's authorization
1) Be careful not to make scratch and molding damage!
1) Be careful not to make scratch and molding damage!
2) Be careful not to make a gap between LCD FPCB
and Main Board.
3) Height of solder should not over 0.2mm.
1) Be careful not to make scratch and molding damage!
2) Don't push the panel of LCD while combine the LCD
1) Be careful not to make scratch and molding damage!
1
2
3
4
Soldering 2 points of MIC FPCB pad with
PBA
Assemble the SHIELD CAN
Combine LCD to Main Board.
Soldering FPCB of the LCD MODULE
CAUTION
Check F-PCB to MAIN PCB soldering tightly.
(If there is a gap between F-PCB and Main board will
makes faulty)
Be careful not to make Flux on the Main
Board
(Use the cover of Soldering Jig)
Push LCD to left and make left hook takes it's
position.
CHECK POINT
1. Order of LCD combining
①
Set LCD rib to it's hole
②
Push and lock the hook which is at right-bottom side of
LCD
③
Push and lock the hook which is at left-bottom side of
LCD
11-2. Assembly
Summary of Contents for GT-E1081
Page 44: ...www s manuals com ...