Samsung FlexDry DVE60M9900W/A3, User Manual

Page: 53 / 228

Maintenance
English 53
Vent sensor
The dryer features a vent sensor that detects and notifies you when it is time to clean the
ductwork. The indicator lets you know the status of the duct.
Level Indicator Status Action
0 Off The ductwork is not clogged. -
1 On
• The duct or lint filter is
clogged.
• High pressure being
applied to the duct
because the duct is too
long or bent.
• Check the lint filter or duct
and clean if necessary.
• Check the duct connections
and shorten or straighten
the duct if necessary.
2 Blinking
• The duct or lint filter is
severely clogged.
• The pressure applied
to the duct is very high
because the duct is too
long or bent.
• Check and clean the lint
filter or duct and make
sure they are not clogged.
• Check the duct connections
and shorten or straighten
the duct work.
If the dryer is in the Level 2 state, the indicator blinks for 3 hours after the completion
of the current cycle. If you press
POWER or open the door, the dryer powers off
immediately.
NOTE
• For duct installation, see Exhaust ducting guide on page 31 and Ducting
requirements on page 18 .
• The dryer may keep running even if the duct is clogged, but the drying time will be
extended.
• If the indicator turns on for the first time and is solid (not blinking), check and clean the
lint filter and/or duct.
• If the indicator turns on again later, it is because the duct is installed or connected with
some restrictions (it’s too long or has too many bends). This is not a system failure.
However, drying time may be extended or the drying performance may be degraded.
FlexDry_DM9900M_DC68-03381F-07_EN.indd 53 2019-06-03 2:28:42