English
56
Oper
ations
Operations
Salt storage
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance. The higher the
content of these minerals and salts, the harder your water is. The softener should be
adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjusting the amount of salt consumed based on
the hardness of the water used. This is intended to optimise and customise the level of salt
consumption so that the salt consumption could be set proceed as follows:
1.
Turn the dishwasher on.
2.
Press and hold the
AUTO
cycle button for five seconds within 60 seconds from turning
on the dishwasher.
- When you entered the Setting mode, the display will show “0:00”.
3.
Press the
Delay Start
button to select the water hardness level setting menu.
- The display shows the current setting. (Default setting: “H4”)
4.
Press the
AUTO
cycle button to change the setting.
- You can select from H1 – H6 (soft – hard).
5.
Wait 5 seconds to save the setting.
NOTE
• It is recommended that adjustments should be made in accordance with the following
(or Manual) table.
• The manufactory setting: H4 (EN50242)
DW7500RM_DD81-02968A-01_EN.indd 56
2019-10-23 10:41:26
Summary of Contents for DW6 R704 BB
Page 74: ...Notizen DW7500RM_DD81 02968A 01_DE indd 74 2019 10 23 10 40 59 ...
Page 75: ...Notizen DW7500RM_DD81 02968A 01_DE indd 75 2019 10 23 10 40 59 ...
Page 150: ...Memo DW7500RM_DD81 02968A 01_EN indd 74 2019 10 23 10 41 31 ...
Page 151: ...Memo DW7500RM_DD81 02968A 01_EN indd 75 2019 10 23 10 41 31 ...
