12_
installing the dishwasher
STEp 6
PlAcING The dIShWASher ANd cONNecTING WATer
SUPPly lINe
1.
Adjust the three leveling legs at the bottom of the dishwasher after measuring the height of
the cabinet opening from under the countertop to the floor. (Refer to the figures in STEP 7.)
2.
Locate the water supply line for connecting the inlet valve on the left and the power cable for
connecting the junction box on the right.
3.
Place the dishwasher so that the water supply line and the power cable are located in the
channels at the base of the dishwasher. Use standard duct tape or cable tie to secure the
water line and electrical cable to their adjacent channels in the base. It can prevent the
squeeze of the water line and electrical cable when placing the dishwasher.
4.
Pull the drain hose through the hole in the side wall to the sink.
5.
Slide the dishwasher carefully into the installation space.
6.
Connect the water supply line into the elbow joint.
Do not place the dishwasher on the water supply line, drain hose or power cable. Also,
make sure they are not folded or twisted.
<Figure 6>
<Figure 7>
installing the dishwasher
CAUTION
Do not overtighten the 90˚ elbow.
Doing so may damage the water
inlet valve and cause a water
leak
power cable
Water supply
line
Drain hose
Water supply line
Elbow( ³/
8
” (9.5mm))
Inlet valve
CAUTION
installation_DD68-00046A-03_EN.indd 12
2010-10-19 �� 2:24:59
