English - 10
English - 10
installing the hob
Be sure the new appliance is installed and grounded only by
qualified personnel.
Please observe this instruction. The warranty will not
cover any damage that may occur as a result of improper
installation.
Technical data is provided at the end of this manual.
SAFETY INSTRUCTIONS FOR THE INSTALLER
•
A device must be provided in the electrical installation that allows
the appliance to be disconnected from the mains at all poles with a
contact opening width of at least 3 mm. Suitable isolation devices
include line protecting cut - outs, fuses (screw type fuses are to be
removed from the holder), earth leakage trips and contactors.
•
With respect to fire protection, this appliance corresponds to EN
60335 - 2 - 6. This type of appliance may be installed with a high
cupboard or wall on one side.
•
Drawers may not be fitted underneath the hob.
•
The installation must guarantee shock protection.
•
The kitchen unit in which the appliance is fitted must satisfy the
stability requirements of DIN 68930.
•
For protection against moisture, all cut surfaces are to be sealed
with a suitable sealant.
•
On tiled work surfaces, the joints in the area where the hob sits
must be completely filled with grout.
•
On natural, artificial stone, or ceramic tops, the snap action springs
must be bonded in place with a suitable artificial resin or mixed
adhesive.
•
Ensure that the seal is correctly seated against the work surface
without any gaps. Additional silicon sealant must not be applied;
this would make removal more difficult when servicing.
•
The hob must be pressed out from below when removed.
•
A board is to be installed underneath the hob.
WARNING
CTR264KC01_XFA DG68-00446A-02_EN.indd 10
2016-09-02 �� 1:29:02
