Samsung Bixolon SRP-500, Command Manual

Page: 23 / 27

Rev. 1.00
- 23 -
SRP-500
①
GS V m
② GS V m n
[Name] Feeds paper for cutting position.
[Format]
①
1 ASCll GS V m
Hex 1D 56 m
Decimal 29 86 m
②
ASCll GS V m n
Hex 1D 56 m n
Decimal 29 86 m n
[Range]
①
m = 1, 49
②
m = 66, 0 ≤ n ≤ 255
[Description] Feeds paper for cutting position as follows;
Bit Print mode
1, 49 Partial cut (one portion left uncut)
66 Feeds paper for ( cutting po [n x 0.122 mm {1/192 inches}]), and partial cut.
[Notes]
This command is effective only at the beginning of a line.
When n = 0, the printer feeds the paper to the cutting position.
When n , 0,the printer feeds the paper to (cutting po[ n x 0.122 mm {1/192
inches}]).
GS a n
[Name] Enable/Disable Automatic Status Back
[Format] ASCII GS a n
Hex 1D 61 n
Decimal 29 97 n
[Range] 0 ≤ n ≤ 255
[Description] Enables or disables ASB and specifies the status items to include,
using n as follows:
Bit Off/On Hex Decimal Status for ASB
Off 00 0 Drawer kick-out connector pin 3 status disabled. 0
On 01 1 Drawer kick-out connector pin 3 status enabled.
Off 00 0 On-line/off-line disabled. 1
On 02 2 On-line/off-line enabled
Off 00 0 Error status disabled. 2
On 04 4 Error status enabled.
Off 00 0 Paper roll sensor status disabled. 3
On 08 8 Paper roll sensor status enabled.
4 - - - Undefined.
5 - - - Undefined.
6 - - - Undefined.
7 - - - Undefined.