89
5.
To create a new connection, press the
Options
soft key, select
New
, and
press the
Select
soft key or the
key.
- or -
6.
To edit the existing AT&T MMS, highlight this entry, press the
Options
soft
key, select
Edit
, and press the
Select
soft key or the
key.
7.
The following parameters are displayed:
• Set Name
: enter a profile name.
• Access Name
: edit the access point name.
• Auth Type
: select the type of authentication used for this WAP connection:
None, Normal, or Secure.
• User ID
: enter the User ID required to connect to the network.
• Password
: enter the user password required to connect to the network.
• Protocol
: set the connection protocol used by the WAP browser: WAP, HTTP, or
Other.
• Home URL
: enter the URL address of the page to be used as your homepage.
• Gateway address
: (wap1.x only) enter the gateway address of the proxy server.
• Proxy address
: (wap2.x and AT&T MMS) set the proxy server address and port.
• Linger Time (Sec.)
: set a time period (in seconds) after which the network is
disconnected if there has been no new data traffic in that time.
• Advanced Settings
: allows you to configure some of the IP-specific
information: Static IP, Static DNS, Server information, and Traffic Class.
-
Static IP
: specify if you want to manually enter an IP address. If you want the IP
address to be automatically assigned by the server, remove the check mark.
-
Local phone IP
: enter the IP address obtained from the network operator, if you
checked the Static IP option.
-
Static DNS
: specify if you want to manually enter the Domain Name Server
(DNS) address. If you want the address to be automatically assigned by the
server, remove the check mark.
-
Server 1/Server 2
: enter the Domain Name Server (DNS) addresses.
-
Traffic Class
: select the traffic class.
Note:
The WAP settings may vary depending on the service provider.
Configuring your Phone’s USB Connection
Your phone can connect to a PC via the USB cable (sold separately). The phone can
be configured to open launch a default application when an active USB connection is
detected.
1.
Use the USB adapter cable to connect the handset to the target PC. When
an active connection has been established, a USB icon (
) appears on