Samsung 1132904, Instructions Manual, Page: 14 / 212

English 14
A
PPENDICES
Troubleshooting Notes and cautions
APPENDICES
Symptom Checklist
Motor does not start. • Check the cable, the power plug and outlet.
Suction force is
gradually decreasing.
• Check if there is any blockage, and remove it if required.
• Please check the filters, and if required, clean as illustrated in
this manual.
– If filters are out of condition, replace them with new ones.
Cord does not rewind
fully. • Pull the power cord out 2 - 3 m and press the Cord rewind
button.
Body overheating
• Check the filters, and clean as illustrated in this manual if
required.
Static electricity
discharge.
• Reduce suction.
• This may also occur when air in the room is very dry. Ventilate
the room so that air humidity becomes normal.
During using, stop the
unit.
• This vacuum cleaner has a special thermostat that protects
the motor in case of its overheating. If the vacuum cleaner
suddenly shuts off, turn off the switch and unplug the vacuum
cleaner. Check the vacuum cleaner for possible source of
overheating such as a full dust bag, a blocked hose, pipe, or
clogged filter. If these conditions are found, fix them and wait
at least 30 minutes before attempting to use the vacuum
cleaner.
• This Vacuum cleaner is approved the following.
– Electromagnetic Compatibility Directive : 2004/108/EEC
– Low Voltage Directive : 2006/95/EC
In use
NOTE
• Product features may vary according to
model.
• When you use the dusting brush or
crevice tool, you may feel vibration from
the vacuum cleaner.
• The operating noise may change once the
safety device is activated to prevent the
dust bag from getting detached.
– The circular tube on bottom of the dust
bag prevents dust from spilling out.
CAUTION
• When removing the power plug from the
electrical outlet, grasp the plug, not the
cord.
• Make sure you don't open the body cover
by pressing the button under the cover
when carrying the vacuum cleaner.
• For storage of the product, park the floor
nozzle in the small groove on the bottom
of the body.
Cleaning and
maintenance
NOTE
• Do not wash the outlet filter with water.
• To maintain the best performance of the
outlet filter, replace it once a year.
• To prevent floors from scratches, inspect
condition of the brush and replace it if it
is worn down.
• Replacement filters are available at your
local Samsung service agent.
• Hold the power cord and then press
the Cord rewind button since you can
get injured if the power cord may lose
control while rewinding it.
• If the power cord is not rewinding well,
press the Cord rewind button again after
pulling the power cord about 2 ~ 3 m.
• When suction power is noticeably
reduced continuously, please clean the
inlet filter by referring to the "Cleaning
the inlet filter" section.
CAUTION
• When suction is noticeably reduced
continuously or vacuum cleaner
abnormally overheats, please clean the
outlet filter.
• Suction may reduce noticeably due to
wrong reassembling of the inlet filter.
• Please contact a nearest service agent if
you cannot remove foreign matters from
the hose.
• Store the vacuum cleaner in the shade to
prevent deformation or discoloration.
VC2500_13ge_00759B-06_GE_resize.indb 14 2019-06-26 오후 1:59:09