Samson TROVIS 6495-2, Mounting And Operating Instructions

Page: 55 / 186

EB 6495-2 EN 7-9
Start-up and configuration
− Switching Controller [1] and Controller
[2] displays
Î
See section 7.1.3.3.
7.1.3.1 Changing the
controller display
The controller display is adapted in the C.5
Controller display submenu of the corre-
sponding Controller [1] or [2] ( 1C.5 or
2C.5 ).
Signals can be selected for each row which
are to be displayed in the operating level.
The type of representation (numerical, bar
graph etc.) can additionally be determined
for the rows 4 and 5.
The following table shows the settings neces-
sary for adapting the display (see Annex A
for details).
Select signal Select type of
representation
Row 1
C.5.1-1…4
–
Row 2
C.5.2-1…2
–
Row 3
C.5.3-1…3
–
Row 4 C.5.4-1…41 C.5.5-1…6
Row 5 C.5.6-1…41 C.5.7-1…6
Example: Based on the default setting (1x
fixed set point/follow-up controller M.1-1)
the output AO1 for Controller [1] in row 5 is
to be displayed as a bar graph.
According to the table above, the setting is
made in
1C Controller [1] menu in the
1C.5.6 Row 5 and 1C.5.7 Row 5 rep-
resentation configuration items.
The controller is currently in the operating
level:
Î
Enter the configuration menu (see sec -
tion 7.1.1).
Configure row 5
2x Select 1C Controller [1] menu.
1x Activate 1C Controller [1] menu.
The 1C.1 Input variables submenu
is highlighted.
4x Select 1C.5 Controller display sub-
menu.
1x Enter 1C.5 Controller display sub-
menu.