Samson TROVIS 5724-3, Mounting And Operating Instructions

Page: 67 / 72

EB 5724 EN 16-3
Annex
16.3 Configuration and parameter list
Configuration list
The function blocks F01 to F14 have the following listed functions.
F = Function block
WE = Default setting 0 = OFF, 1 = ON
F Function WE Meaning
01 DHW tapping recognition 1 0: Continuous control
1: Flow rate sensor active
02 Flow rate sensor 1 0: Flow switch
1: Water flow sensor
03 Adaptation 1 0: Passive
1: Active (with water flow sensor)
04 Direction of action 0 0: >> (increasing/increasing)
1: <> (increasing/decreasing)
05 Current input 0 0: Passive (binary input)
1: Active
06 Function of current input 0 0: Actual value
1: Set point
07 Measuring range of cur-
rent input
0 0: 0 to 20 mA
1: 4 to 20 mA
08 Function of binary input 0 0: Termination of maintaining heat exchanger at constant
temperature
1: Switchover between internal set points
09 Maintain heat exchanger
at constant temperature
0 0: Time adjustable
1: Continuous
10 Upper limit (GWH) 0 0: No limitation
1: Exceeding GWH causes switch-off
11 Lower limit (GWL) 0 0: No frost protection
1: Violation of GWL causes frost protection to start
12 Manual set point 1 0: No manual adjustment
1: Manual adjustment effective above 10 %
16 Function of switching out-
put
3 1: Passive
2: Fault alarm
3: Circulation pump (DHW)
4: Circulation pump (heating)
5: Tapping
6: Circulation pump (heating) reversed
17 Pump protection 1 0: No
1: Yes