Samson TROVIS 3730-3, Mounting And Operating Instructions

Page: 135 / 180

EB 8384-3 EN 135
Appendix
Code
no.
Parameter – Readings/
values [default setting]
Description
39 Set point deviation e info
–99.9 to 99.9 %
Read only
Indicates the deviation from the target position (e = w – x).
40 Transit time Open info
[0] to 240 s
Read only
Minimum opening time determined during initialization.
41 Transit time Closed info
[0] to 240 s
Read only
Minimum closing time determined during initialization.
42 Auto-w info
0.0 to 100.0 % of the
span
Read only
Indicates the applied automatic set point with corresponding 4 to
20 mA signal.
43 Firmware info Read only
Indicates the positioner type and current firmware version in alter -
nating sequence.
44 y info
[0] to 100 %, 0P, MAX,
– – –
Read only
Indicates the control signal y in % in relation to the travel range de -
termined during initialization.
MAX: The positioner builds up its maximum output pressure,
see description in Code 14 and 15.
0P: The positioner vents completely, see description in
Code 14 and 15.
– – –: The positioner is not initialized.
45 Solenoid valve info
YES, HIGH/LOW, No
Read only
Indicates whether a solenoid valve is installed or not.
If a voltage supply is connected at the terminals of the installed sole-
noid valve, YES and HIGH appear on the display in alternating se-
quence. If a voltage supply is not connected (actuator vented, fail-
safe position indicated on the display by the S icon), YES and LOW
appear on the display in alternating sequence.
46* Polling address
[0] to 63, ESC
Select bus address
47* Write protection HART ®
YES, [No], ESC
When write protection is active, device data can be read, but not
overwritten over HART ® communication.
48*
49*
Diagnostic parameters
u
EB 8389