Samson Media 7, Mounting And Operating Instructions

Page: 33 / 96

EB 9510 EN 33
Mounting and start-up
5 Mounting and start-up
Risk of damage to the device due to incorrect
mounting position.
− Keep rear blow-out opening clear.
− Mount the device in the upright position
only:
5.1 Preparation for installation
Proceed as follows:
Î
Flush the pipeline thoroughly before in-
stallation of the Media 7 device.
Î
Check the Media 7 device to make sure
that it is clean and not damaged.
The plant operator is responsible for clean-
ing the pipelines in the plant.
1
2
2
1
3
3
4
4
1 M8 tapped hole
2 Through hole for M8 screw
3 Screw fitting for measuring line (dp cell)
4 Screw fitting for measuring line (valve block)
5 Screw plug
5
5
Fig. 6: Fastening holes and measuring line connections of Media 7
NOTICE !
Note