EXL250m REAR PANEL
1
HIGH FREQUENCY
- Controls the high band of the
Channel Equalizer, +/- 15 dB at 12KHz.
2
LOW FREQUENCY
- Controls the low band of the
Channel Equalizer, +/- 15 dB at 80Hz.
3
REVERB
– Effect send connected to the internal
effect processor.
4 PAN
– Controls the channel’s position between left
and right in the stereo bus.
5
VOLUME CONTROL
– Provides smooth control over
level changes.
6 LINE
– Line Input connector on the mono chan-
nels.
7 MIC
- XLR connector for low impedance micro-
phone input. 24 volt phantom power is supplied.
8 BALANCE-
Controls the left and right placement of
the stereo signal in the main mix output
9 CH 3/4 LINE IN
– Stereo Line Input TRS connection
Tip=Left, Ring=Right, Sleeve=Ground.
10 CH 3/4 MIC IN
- XLR connector for low impedance
microphone input.
11 SCRIBE STRIP -
Use grease pencil or place tape
here to label channels.
12 POWER
– Switches on the EXPEDITION EXPRESS’
main power.
13 AC VOLTAGE SWITCH
– Selects the operating
voltage. Make sure this switch is set correctly
for the country you are in before turning on the
EXL250m.
14 AC POWER INLET
– Connect External AC power
supply here.
15 LIMITER LED -
Lights whenever the built-in
Limiteris active. If you see this lighting frequent-
ly, it means you’re overloading the EXL250m.
Turn down one or more of the channel Volume
controls or the Main Volume control.
16 CD INPUTS
– Connect a CD, DAT, Cassette or
Mini Disk here.
17 SPEAKER OUT
– Connect EXL250e external
speaker here.
18 MAIN VOLUME
- Used to control the overall vol-
ume of the Left and Right main Mix outputs.
19 DSP EFFECTS -
Used to switch between the 6 pre-
sets of the internal DSP effects processor.
Expedition Express Rear Panel Layout
EXL250e REAR PANEL
A SPEAKER INPUT
– Connect speaker cable from
EXL250m SPEAKER OUT here
ENGLISH
7
Summary of Contents for Expedition Express EXL250
Page 1: ...EXL250 PORTABLE PA SYSTEM SOUND REINFORCEMENT ...
Page 2: ......