Samson 5827, Mounting And Operating Instructions, Page: 82 / 92

16-8 EB 5827-2 EN
Annex A (configuration instructions)
16.5.7 Start-up
Initialization can be started in the 'Service' folder ('Start-up').
16.5.8 Functions ('Service' folder)
The following functions can be performed in the 'Service' folder ('Functions'):
16.5.8.1 Manual level
The actuator can be switched to the manual mode using the TROVIS-VIEW software if the
manual level is enabled in online mode. The actuator leaves the manual mode as soon as
you exit the manual level or the online mode in TROVIS-VIEW.
The following actions can be activated in the manual level:
− Retract actuator stem
− Extend actuator stem
− Move stem to standardized value
Î
First enter the required positioning value in relation to the input signal range (standard-
ized positioning value).
− Issue standardized position feedback
Î
First enter the required position feedback in relation to the span of the position feedback
signal (standardized position feedback).
− Issue error message
− Activate the yellow LED
− Activate the red LED
16.5.8.2 Functions
Perform reset
The actuator is restarted.
Load default settings in actuator
The configuration is reset to the default setting.