Samson 5827, Mounting And Operating Instructions, Page: 17 / 92

EB 5827-2 EN 3-3
Design and principle of operation
Serial
interface
Fig. 3-2: Serial interface
Configuration
The actuator is configured with the TROVIS-
VIEW software. In this case, the serial
interface on the actuator is used to connect
the actuator to the computer.
The TROVIS-VIEW software enables the user
to easily configure the positioner as well as
view process parameters online.
TROVIS-VIEW can be downloaded free of
charge from our website at
u
www.samsongroup.com > Service &
Support > Downloads > TROVIS-VIEW.
Further information on TROVIS-VIEW (e.g.
system requirements) is available on our
website and in the Data Sheet
u
T 6661 as
well as the Operating Instructions
u
EB 6661.
Î
See the 'Start-up and configuration' sec -
tion.
3.3 Additional equipment
Limit contacts
Devices in 24 V version can be fitted with
limit contacts. The limit contacts consist of
two changeover switches. Their switching
positions are changed independently from
one another by continuously adjustable cam
disks. The floating contacts can be used as
either make or break contacts to influence
the tasks of control equipment.
The adjustment of the limit contacts is de-
scribed in the 'Installation' section.
It is not possible to retrofit limit contacts.
Note