Samson 5343, Mounting And Operating Instructions

Page: 28 / 60

5-4 EB 5206 EN
Installation
95 95
42,4 95,4
Ø 4,
5
Ø 4,
5
Single
thermostat
Double
thermostat
Fig. 5-4: Drill templates · Dimensions in mm
5.4.2 Mounting on tanks or in
pipes
The thermostat is fastened to the thermowell
which is screwed into place.
1. Insert the seal (6).
2. Screw the thermowell (7) into the pipe or
tank.
3. Insert the small metal plate (7b) at the
back of the housing (1) and secure in
place with the screw (7c).
4. Push the sensor (2) as far as it will go in -
to the thermowell (7), making sure that
the round hole at the back of the housing
(1) rests on the collar on the thermowell.
5. Push the thermostat approx. 2 mm
lengthways toward the SAMSON logo to
allow the thermowell to engage.
6. Turn the screw (7c) until the housing is
fixed into place on the thermowell.
7. Connect the wiring as shown in sec -
tion 5.5.
8. Screw the front cover back onto the ther -
mostat.
Temperature regulators (TR):
Î
Place the set point adjuster on the shaft.