Samson 42-10, Mounting And Operating Instructions

Page: 11 / 76

EB 3009 EN 1-7
Safety instructions and measures
1.3 Notes on possible property damage
NOTICE
!
Risk of regulator damage due to incorrectly attached slings.
Î
Do not attach load-bearing slings to the actuator housing.
Risk of regulator damage due to unsuitable medium properties.
The regulator is designed for a process medium with defined properties.
Î
Only use the process medium specified for sizing.
Risk of regulator damage due to contamination (e.g. solid particles) in the pipeline.
The plant operator is responsible for cleaning the pipelines in the plant.
Î
Flush the pipelines before start-up.
Risk of regulator damage due to the use of unsuitable lubricants.
The lubricants to be used depend on the regulator material. Unsuitable lubricants may
corrode and damage surfaces.
Î
Only use lubricants approved by SAMSON.
When in doubt, consult SAMSON.
Risk of leakage and regulator damage due to excessively high or low tightening
torques.
Observe the specified torques when tightening regulator components. Excessive tight -
ening torques lead to parts wearing out more quickly. Parts that are too loose may
cause leakage.
Î
Observe the specified tightening torques (see 'Tightening torques' in Annex).
Risk of regulator damage due to the use of unsuitable tools.
Certain tools are required to work on the regulator.
Î
Only use tools approved by SAMSON.
When in doubt, consult SAMSON.