Samson 3730-4, Original Instructions Manual

Page: 76 / 128

76 EB 8384-4 EN
Operation
8 Operation
Risk of injury due to the actuator stem ex -
tending or retracting.
Do not touch or block the actuator stem.
8.1 Enabling and selecting pa-
rameters
All codes and their meaning and default set-
tings are listed in the code list in section 14.
Codes which are marked with an asterisk
must be enabled with Code 3 before the as -
sociated parameters can be configured as
described below.
Code 3
Configuration not enabled
Configuration enabled
Turn
g
Code 3, display: No
Press , Code 3 blinks.
Change the setting in Code 3.
Turn

YES
Press , display:
Configuration is enabled.
You can now configure codes one after the
other:
Turn to select the required code.
Press to activate the selected code. The
code number starts to blink.
Turn to select the setting.
Press
to confirm the selected setting.
If no settings are entered within 120 sec -
onds, the enabled configuration function be -
comes invalid and the display returns to
Code 0.
Cancel the setting:
Canceling the reading
To cancel a value before it is confirmed (by
pressing ) proceed as follows:
Turn
g
ESC
Press .
The entered value is not adopted.
8.2 Operating modes
8.2.1 Automatic and manual
modes
After initialization has been completed suc -
cessfully, the positioner is in automatic
mode (AUTO).
WARNING !
Note