Samson 3595, Mounting And Operating Instructions

Page: 73 / 76

EB 8079 EN 15-3
Annex
Tools
In addition to the standard tool, special tools
are required to assemble and remove some
parts. Use adjustable torque wrenches with a
stop signal or that indicate the torque being
applied to achieve the right tightening
torques. Valves in large valve sizes often re-
quire tightening torques that can only be
achieved through additional torque multipli-
cation by using a torque multiplier or hy-
draulic power tool.
Contact SAMSON’s After-sales Service con-
cerning the special tools required.
15.2 Spare parts
Contact SAMSON’s After-sales Service if
you need spare parts.
15.3 After-sales service
Contact our after-sales service for support
concerning service or repair work or when
malfunctions or defects arise.
E-mail address
You can reach our after-sales service at
aftersalesservice@samsongroup.com.
Addresses of SAMSON AG and its subsid -
iaries
The addresses of SAMSON AG, its subsid-
iaries, representatives and service facilities
worldwide can be found on our website
(www.samsongroup.com) or in all SAMSON
product catalogs.
Required specifications
Please submit the following details:
− Order number and position number in
the order
− Type, model number, nominal size and
valve version
− Pressure and temperature of the process
medium
− Flow rate in cu.ft/min or m³/h
− Type and bench range of the actuator
(e.g. 0.2 to 1 bar)
− Is a strainer installed?
− Installation drawing