Samson 3275A, Mounting And Operating Instructions, Page: 39 / 52

EB 8314-1 EN 10-1
Decommissioning
10 Decommissioning
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
Risk of bursting due to incorrect opening of
pressurized equipment or components.
Pneumatic actuators are pressure equipment
that may burst when handled incorrectly.
Flying projectile fragments or components
can cause serious injury or even death.
Before working on the actuator:
Î
Depressurize all plant sections concerned
and the actuator. Release any stored en‑
ergy.
Risk of personal injury due to exhaust air
being vented.
The actuator is operated with air. As a result,
air is vented during operation.
Î
Wear eye and hearing protection when
working near the actuator.
Crush hazard arising from the moving
actuator stem.
Î
Do not insert hands or finger into the
yoke while the air supply is connected to
the actuator.
Î
Before working on the actuator, discon‑
nect and lock the pneumatic air supply
as well as the control signal.
Î
Do not impede the movement of the actu‑
ator stem by inserting objects into the
yoke.
To decommission the actuator for service
work or before removing it from the valve,
proceed as follows:
1. Put the control valve out of operation.
See associated valve documentation.
2. Disconnect the pneumatic air supply to
depressurize the actuator.
3. Release any stored energy.
DANGER !
WARNING ! WARNING !
WARNING ! WARNING !