Samson 2403, Mounting And Operating Instructions, Page: 29 / 32

EB 2183 EN 29
Decommissioning and removal
9.2 Disposal
SAMSON is a producer
registered at the following
European institution
u
https://www.ewrn.org/
national-registers/national-
registers.
WEEE reg. no.:
DE 62194439/FR 025665
Î
Observe local, national and internation-
al refuse regulations.
Î
Do not dispose of components, lubricants
and hazardous substances together with
your other household waste.
We can provide you with a recycling
passport according to PAS 1049
on request. Simply e-mail us at
aftersalesservice@samsongroup.com giving
details of your company address.
On request, we can appoint a service pro-
vider to dismantle and recycle the product as
part of a distributor take-back scheme.
Note
Tip
Risk of burn injuries due to hot or cold com-
ponents and pipelines.
Depending on the process medium, valve
components and pipelines may get very hot
or cold and cause burn injuries.
− Allow components and pipelines to cool
down or warm up to the ambient tempera-
ture.
− Wear protective clothing and safety gloves.
9.1 Decommissioning
To decommission the safety temperature
monitor before removing it, proceed as fol-
lows:
1. Close the shut-off valve on the upstream
side of the valve.
2. Close the shut-off valve on the down-
stream side of the valve.
3. Completely drain the pipelines and
valve.
4. Depressurize the plant. Shut off or dis-
connect the control line, if installed.
5. If necessary, allow the pipeline and de-
vice to cool down or warm up to the am-
bient temperature.
6. Remove the sensor from the pipeline
and, if necessary, seal the opening.
7. Remove the safety temperature monitor
from the valve.
WARNING !