Revised A
68
6301
7. Cleaning procedure (continued)
7.2.2. Shaping air shroud
• Step 1: Remove the aluminium cover to remove the shaping air shroud
• Step 2: Clean outside and inside surfaces with a rag dipped in solvent and a nylon brush.
• Step 3: Dry well with compressed air and a clean dry rag.
7.2.3. Injector and injector holder
• Step 1: Remove injector as per instruction (
)
• Step 2: Soak 1 hour in approved cleaning solution
• Step 3: Dry with compressed air
1
Aluminium cover
2
O-ring 88.62 x 1.78 teflon encapsulated
3
Shaping air shroud
4
Injector solvent with o-ring 2.9 x 1.2 chemically inert
DES01052
1
2
3
4
DES01099
Step 2
Step 3
