Sames inocoat Inogun A, Instruction Manual

Page: 10 / 87

10
Member of Exel group
DRT7133
D - 2023/01
1.4. Precautions for Use
This document contains information that all operators should be aware of and understand before using the projector.
This information highlights situations that could result in serious damage and indicates the precautions that should
be taken to avoid them.
Before any use of the Inogun A, check that all operators:
• have previously be trained by the company Sames , or by their distributors registered by them for this
purpose.
• have read and understood the user manual and all rules for installation and operation, as laid out
below.
It is the responsibility of the operators’ workshop manager to ensure these two points and it
is also his responsibility to make sure that all operators have read and understood the user
manuals for any peripheral electrical equipment present in the powdering area.
1.5. Warnings
It is imperative that anyone wearing a pacemaker does not use the equipment and does not
enter the projection area.
High voltage can cause the pacemaker to malfunction.
This equipment may be hazardous if it is not used, disassembled and reassembled in
accordance with the rules indicated in this manual and in any applicable European Standard or
national safety regulations.
Equipment performance is only guaranteed if original spare parts distributed by Sames
are used.
To guarantee an optimal assembly, spare parts must be stored in a temperature close to their
temperature of use. Should the opposite occur, a sufficient waiting time must be observed
before the installation, so that all the elements are assembled in the same temperature.
This equipment is intended for spraying powder paint only.