Disassembly / Reassembly Operation
582127110-2B1000-indD-EN.docx
06/11/2020
41
ISO FLANSH flange seal
Unscrew the 4 screws (11),
Take off the ISO FLANSH flange (10) and the seal (12)
Clean all the parts, check them; if there are damaged or
worn, change them,
Clean and reinstall the parts in the reverse order of the
disassembly sequence.
Reassembly of the fluid section
Lubricate the cup seals and piston rod seals,
Slide the piston rod assembly (20) inside the fluid flange
(8), push it upwards,
Screw the cylinder (18) into the fluid flange (2),
Apply glue (e.g. Loctite 222) to the screw (29),
Screw the screw (29) into the seat 27),
Screw the foot valve body assembly (38) the O-Rings (39),
the flange (40). Tighten slightly,
Reinstall the protection (45), and the tie-rods (46).
Couple the fluid section to the pneumatic motor.
NOTA : The quantity of seals of the packing (11) depends
upon the used package of seals.
