39
DRT7105
G - 2022/11
Member of EXEL group
6.4. Replacement
6.4.1. Procedure B1: Replacement of the paint hoses
6.4.1.1. Paint hose - QD version (HR)
•
Step 1
: Side handle, unscrew the fitting using
a 15mm open-ended spanner.
•
Step 2
: Release the paint hose from base.
•
Step 3
: Using a 21 mm open-ended spanner,
unscrew the upper nut of the paint hose, then
stop loosening manually by maintaining the
nut of bottom.
•
Step 4
: Check that the seal of the paint nut is
in place. Check that the two olives (P/N
910018200) are installed on the paint hose
(they can be lost in the event of leakage
caused by inadequate tightening). In case
olives must be removed, replace them
necessarily by news.
To reassemble,
follow the steps in reverse order.
Tighten manually the upper paint hose nut until it
levels the reinforcement of the barrel.