Doc.-ID: 181210-PT10BA-ES-RoughCam IPM3016_en_rev.00.docx, page 12 of 24
Figure 4.5
– RoughCam IPM3016 T10-VA1.2.K1.BOR-
LL
.N-xxx.N-P-0xx
Via the 8 (+1) wire green patch cable the digital video stream is transferred via IP/ TCP/
RTSP protocol levels and the camera module is controlled and/or parametrized via the
web interface or the video management software.
The power supply of the PoE camera and the optional heating mode (none-PoE) is con-
ducted via this cable. In order to guarantee the power supply of the T10 RoughCam
IPM3016 (
Powered Device
/ PD), a Power-over-Ethernet component (Power Sourcing
Equipment, PSE) has to be available at the connecting side (e.g. a PoE Switch, a PoE
Injector, or Midspan) which meets the specification IEEE 802.3af or 802.3at type 1 class
1
2
. The interface of the RoughCam IPM3016 uses a 100 Mbit/s
„Fast Ethernet“- connec-
tion for the data transfer (100BASE-TX).
4.2.3
Connector pin assignment (RJ45)
In case the camera disposes of a plug (figure 4.4); it has to be plugged into the RJ45
PoE slot of the network device. Due to the design, a faulty connection or pin assignment
is not possible. The network device can already be supplied with power, prior to connect-
ing it to the camera, hence there is no „power ON“ priority which has to be observed.
Figure 4.6
– RJ45 Pin assignment and cable pin assignment
2 Classification power: 9-
12 mA, nominal voltage 48 V DC (44…54 V DC),maximum feed power PSE: 4.0 W, removal performance PD: 0.44 W – 3.84 W
9
