18
TORNADO
ROTARY SNOW BLOWER
OPERATOR’S MANUAL
Tab. 4
.
List of telescopic articulated shafts
Telescopic
articulated shaft
Symbol
Clutch
Manufacturer
Fr
ont
lin
kag
e
WET
8G7N061CE007003
left-hand overrunning clutch
Bondioli & Pavesi
OET
8G7N061CE007004
right-hand overrunning clutch
Re
ar
lin
kag
e
OET
Built-in shaft
7G3N046FX0070F3PYA
overload clutch
It is possible to use shafts with similar technical parameters from different manufacturers after
consulting SaMASZ.
4.3.
Transport and standstill position
When transported the blower should be lifted and protected against accidental falling (e.g. by
means of 3-point linkage lock in tractor). When in standstill, blower mounted on tractor should lean
the ground with blade. Blower which is not mounted on tractor should be supported on the blade or
sliding skids.
Fig. 11.
a)
Standstill position, b) transport position
4.4.
Controlling rotary snow blower
In order to lift/lower the machine, use control lever for tractor's front 3-point linkage. To adjust
the tube's blowing direction and distance use corresponding sections of hydraulic distributor, which
is controlled from the operator's position by starting the corresponding external hydraulics circuit, to
which blower's hydraulic hoses are connected.
Blowing distance is dependent upon the tube's setting, snow properties, rotary speed of the
rotor and can range from 3 up to 20 m.
NOTE:
When operating DO NOT direct the tube at the operator's cabin as well as at any
unauthorized personnel, animals nor facilities.
a)
b)
