SaMASZ PT3 190, Operator'S Manual

Page: 16 / 28

16
PT CIRCULAR SAW OPERATOR ’ S MANUAL
N-219
This applies to a Fisher-compatible circular saw
(motor with absorbing capacity of 26 cm
3
– without oil separation pipe)
5. USAGE
5.1. Coupling the circular saw and an extension arm
In order to mount the circular saw on an extension arm the following should be performed:
❑
Prepare the circular saw to be mounted on an extension arm by setting it on an even, stable ground.
❑
Lift the extension arm and drive at the prepared operating head.
❑
Position the end of the extension arm so it is place for attaching the saw connection plate.
❑
Turn tractor's engine off, secure with the parking brake and take ignition key off.
❑
Couple both of the connection plates by proper tightening of six bolts M14 – apply proper torque
( Tab. 3 ).
❑
Using hydraulic couplings.
WARNING!
For a Fisher-compatible circular saw version, the circular saw hydraulic motor
has no third oil separation pipe, and thus the return hose with female connector
at the end must be connected to the connector with pressure-less return line.
Otherwise hydraulic motor can be damaged.
If the vehicle has no hydraulic connector with pressure-less return line, refer to
the instruction manual, or consult the vehicle's manufacturer where pressure-
less return line can be connected to the tank.
5.2. Circular saw control
Controlling the circular saw is possible thanks to individual control panel of extension arm.
Operating instructions of the extension arm must be learned.